|
|
| |
| Products |
|
 |
Flow Controller for General Liquid |
|
|
|
|
|
 Click to enlarge image
|
 Origin |
Korea |
| Model Number |
FC410C |
Feature
- Gross and net total/ gross or net accumulated total/ gross and net flow rate
- 4-20mA and Pt 100 Ohms Temperature inputs
- Gross or net scaled pulse output
- 4-20mA Analog output
- Alarm output
Over View
The FC410C Series flow controllers are designed to measure volumetric flow for liquids with temperature input. This corrected volume is at standard reference condition. This Series is ideally suited to custody transfer applications and includes the API/ASTM equations covering general petroleum products and LPG. The BC410C Series is direct RTD input or 4-20mA temperature input.
General
| Display |
7-digit 14.1mm(0.56Inch)7-segment LED |
| Display Update Rate |
0.25-second |
| Decimal Points |
Fully programmable for Rate and Total |
| Time Base |
The Rate can be displayed in unit per second, per minute, per hour or per day |
| Data Retention |
Set up parameters and totals stored in non-volatile memory with 10 years retention |
| Operation Temperature |
0°C to 55°C |
| Power |
AC 85-264V / DC 24V |
| Power Consumption |
10VA |
| Transducer Supply |
8V or 12V selectable, 50mA max |
Flow Inputs
| Frequency(Pulse) Input |
| Frequency Range |
0 to 5 kHz |
| Signal Type |
sine wave, open collector, reed switch, proximity switch, voltage and current pulse |
| K-factor Range |
0.0001 - 50000.0000(the pulse per units) |
| Analog Input |
| Inputs |
4-20 mA or 1-5V option |
| Input Impedance |
Current 250 ohms
Voltage 10K ohms |
| Accuracy |
0.05% |
| Span |
0.0001 to 50000.0000 |
| Zero |
0.0000 to 50000.0000 |
| Cut-off Point |
A low flow rate cut-off can be programmed below which flow is not registered. The cut-off is programmed as a percentage of span relationship Linear or square root or programmable open Channel For open channel flow meters; the power of The input relationship is programmable between 0 and 9.99. |
Temperature Input
| RTD Input |
| Type |
Platinum PT100(DIN) |
| Temperature Range |
-50(-58°F) to 50°C(122°F)(Refer to the ordering information for detail) |
| Accuracy |
0.1°C |
| Linearity |
The non-linearity of the RTD is internally compensated for. |
| Analog Input(4-20 mA) |
| Inputs Impedance |
250 ohms |
| Measurement Range |
-273°C(-459.4°F) to 1200°C(2192°F) |
| Accuracy |
0.05% |
Pulse Output
| Function |
Open collector output with a pulse produced on each increment of the accumulated total(gross, net, mass or energy). |
| Pulse Width |
10 ms(negative going pulse) |
| Duty Cycle |
49 pulses/sec. Max. |
| Output |
Current sinking output transistor 50mA, 30vdc max.(Pulse output is suitable for driving remote counter or PLC's) |
Relay Output
| Function |
High and low, high-high and high or low and low-low flow rate alarms based on the flow rate in energy gross volume, net volume, mass or energy |
| Max. Switching Power |
2000VA, 240W |
| Max. Switching Voltage |
AC250V, DC30V |
| Max. Switching Current |
8 Amps |
4-20mA Output
| Function |
Outputs flow rate in gross volume, net volume, mass or energy, The 4 and 20 mA points can be programmed to provide a fully scaled output. |
| Resolution |
12-bit |
| Accuracy |
Better than 0.025% |
| Maximum Load |
500 ohms internally powered. 950 ohms from external 24V dc. |
| Isolation |
Output is isolated. |
RS232/422/485
| Type |
Both RS232 and RS422/485 are provided.(Note : When using the RS422/485, multi drop communication can be implemented with up to 32 instruments connected to a common bus. |
| Function |
Printer and computer protocols are fully programmable. |
| Printer |
A print is initiated on each reset or at a programmable time interval. |
| Computer |
An ASCII based protocol enable all display parameters to be read and the totals to be reset. |
| Baud Rate |
1200 to 19200 BPS |
| Data Bit |
8-bit |
| Parity Bit |
None |
| Data Logging |
Output generated at intervals of once a minute to once every 24 hours. The total can be programmed to reset on each print or at 24:00 hours |
| Time |
A real time clock is provided to give time and date on each output. |
Error Output
| Function |
The Error output is out of range, no flow or communication fail indicated |
| Output |
An open collector transistor will sink 50 mA max. |
Enclosure
| Basic Enclosure |
| Dimension |
72mm (H) x 144mm (W) x 177mm (D) |
| Material |
Polycarbonate, Aluminum |
| Panel Cutting Size |
67mm x 139mm(±0.2mm) |
| Weather Proof |
| Protection |
IP65(Nema 4X) |
| Material |
Aluminum |
| Outside Dimension |
248mm (H) x 162mm (W) x 87mm (D) |
| Explosion proof |
| Outside Dimension |
270mm(H) x 290mm(W) x 280(D) |
| Mounting Dimension |
90mm(H) x 83mm(W) x M8 Bolt |
| Classification |
Division 1, Class I Group-A, B,C,D
Class II Group-E, F&G
ClassIII
Zone 1 or 2, Exd II B T6
|
Standards and Approvals
CE
Manufactured under ISO 9001
Dimension
Ordering information
| MODEL |
Order Code |
Description |
| FC410C- |
|
|
|
|
|
|
Flow Controller with LCD Display(LED-Backlight) |
| Flow Senseor |
P
A |
|
|
|
|
|
Frequency Type Flow Meter Input
4-20mA Analog Type Flow Meter Input |
| Temperature |
|
A
R |
|
|
|
|
4-20mA Analog Temperature Input
Pt 100 Ohms RTD Input(0~100°C) |
| In/Output |
|
|
0
1
2 |
|
|
|
Basic Mode(No Option)
4-20mA Analog Output
Remote Switch Input |
| Communication |
|
|
|
0
1
2 |
|
|
None Communication
RS-232 Communication
RS-422/RS-485 Communication |
| Power |
|
|
|
|
A
D |
|
AC 85-264V(Free Voltage)
DC 24V |
| Case |
|
|
|
|
|
0
1
2 |
Only Basic
With Weather Proof
With Explosion Proof
|
|
|
|
|
| |
|
|
|
Related Keywords:
Bookmark / Share this page